Week 6
Title of the project: Design PIC and heater circuit
Objective: To build the interfacing circuit between the motor, heater and PIC circuit
Content/Procedure:
Design circuit by using software
Analysis:
After complete design using proteus, circuit on software will be transform to be an actual circuit. By using Protel Design System, it already locates component and connection of each component. Student should re-check to make sure have no overlapping layer and circuit will be adjust as needed. The important thing, this software will build as an actual circuit, mean component can be place into circuit with component pin can be place at PCB board.
Conclusion:
This circuit is use to connect between the component in circuit. It can be design as expectation of sizes at the PCB board. So, student can print the design and it ready to paste into PCB board.
No comments:
Post a Comment